Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2010 >> 9-5 >> Repair and Diagnosis >> Brakes >> Traction Control >> TCS/Esp >> Fault diagnosis, fault codes >> DTC C0267: Low Brake Fluid Level Is Indicated >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B20 Brake Fluid Level Switch.
  2. Check that the resistance between the ground circuit terminal 2 and ground is less than 5 Ω.

    ==> If resistance is greater than the specified value, test the ground circuit for an open circuit/high resistance.

  3. Ignition ON, verify the scan tool Brake Fluid Level Sensor parameter is Low.

    ==> If the value is not as specified, test the signal circuit for a short to ground. If the circuit tests normal, replace the K17 Electronic Brake Control Module (EBCM).

  4. Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground.
  5. Verify the scan tool Brake Fluid Level Sensor parameter is OK.

    ==> If the value is not as specified, test the signal circuit for a short to voltage or an open circuit/high resistance. If the circuit tests normal, replace the K17 Electronic Brake Control Module (EBCM).

  6. If all circuits test normal, test or replace the B20 Brake Fluid Level Switch.
scientia non olet · About Mike's Workshop Manuals