Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2007 >> 9-7X 5.3i >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 5.3L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

IMPORTANT: Lightly coat the MAP sensor seal with clean engine oil before installing the sensor.
  1. Install the MAP sensor (1). Push the MAP sensor into the intake manifold.
    Fig 1: Identifying MAP Sensor & Retaining Clip
    GM1509706Courtesy of GENERAL MOTORS CORP.
  2. Install the MAP sensor retainer (2) to the intake manifold.
  3. Connect the MAP sensor electrical connector (3).
    Fig 2: Top Of Engine Wiring Harness View
    GM898326Courtesy of GENERAL MOTORS CORP.
  4. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About Mike's Workshop Manuals