Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2007 >> 9-7X 4.2i >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the knock sensor harness connector (4).
    Fig 1: Locating Knock Sensor Components
    GM727528Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor retaining bolt (3).
  4. Remove the appropriate knock sensor (1 or 2).
scientia non olet · About Mike's Workshop Manuals