Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2007 >> 9-7X 4.2i >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Fuel Tank Replacement >> Assembly Procedure

Assembly Procedure

  1. Install the fuel sender assembly (4) to the fuel tank. Refer to Fuel Sender Assembly Replacement .
    Fig 1: View Of Connections On Top Of Fuel Tank
    GM1480091Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP vent valve (8). Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement .
  3. Install the EVAP canister purge pipe (2) to the fuel tank.
    Fig 2: Identifying EVAP Hose Assembly (3) From Fuel Tank Vent Valves & Fuel Module
    GM1480093Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP pipe assembly (3) to the fuel tank.
  5. Connect the EVAP pipe assembly (3) to the tank vent valves and fuel sender. Refer to Plastic Collar Quick Connect Fitting Service .
  6. Install a new tie (1) to secure the EVAP pipes together.
  7. Install the fuel feed pipe (1) to the fuel sender module (4) and retaining clip (3). Refer to Plastic Collar Quick Connect Fitting Service .
    Fig 3: Locating Fuel Feed Pipe (1), Fuel Sender Module (4) & Retaining Clip (3)
    GM1480090Courtesy of GENERAL MOTORS CORP.
  8. Install a new tie (2) securing the fuel feed pipe and EVAP canister purge pipe together.
scientia non olet · About Mike's Workshop Manuals