Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2007 >> 9-7X 4.2i >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 4.2L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install the CMP sensor.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the CMP sensor electrical connector (1).
scientia non olet · About Mike's Workshop Manuals