Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2007 >> 9-7X 4.2i >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Introduction >> Repair Instructions >> Ignition Switch Lock Cylinder Replacement >> Installation Procedure

Installation Procedure

  1. Slide the lock cylinder into the ignition switch housing.
    Fig 1: Removing/Installing Ignition Switch
    GM1554774Courtesy of GENERAL MOTORS CORP.
  2. Insure the lock tab on the cylinder is secure.
  3. Install the ignition switch. Refer to Ignition and Start Switch Replacement .
  4. Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement .
scientia non olet · About Mike's Workshop Manuals