Control module calibration

The system must be calibrated after replacing a control module as well as a front or rear load angle sensor. The system must also be calibrated after a front or rear load angle sensor is loosened or removed.

Control the following points before beginning calibration.

• The car should be level.
• The car should be unloaded.
• Check that the light image has not been reset to the right-hand/left-hand traffic "tourist solution"
• Stabilise the suspension by rocking the car.
• The handbrake must not be applied.
• Steering wheel and wheels in straight-ahead position.
• Ignition in ON position
• The Xenon lamps should be lit.

Connect the diagnostic tool and calibrate the control module.

Check the function of the headlamps and clear any DTCs.

Check the light setting and adjust as necessary.