Circuit Description

The accelerator pedal assembly contains 2 Accelerator Pedal Position (APP) sensors. The APP sensors are mounted in the pedal assembly and are not serviceable. The APP sensors provide a signal voltage that changes relative to the position of the accelerator pedal. The Engine Control Module (ECM) supplies a separate 5-volt reference and low reference circuit for each of the APP sensors.

The APP sensors have opposite functionality. The APP sensor 1 signal voltage increases as the pedal is depressed, from approximately 1 volt at rest to above 4 volts when fully depressed. The APP sensor 2 signal voltage decreases as the pedal is depressed, from 4 volts at rest to less than 1 volt with the accelerator pedal fully depressed.

If the ECM detects that the APP sensor 1 signal voltage is too high, this DTC sets.