Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction & Repair Procedures >> Repair Instructions >> Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Transmission Heat Shield Bolts & Shield
    GM394459Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission heat shield to the transmission.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the two bolts securing the transmission heat shield to the transmission.

    Tighten:  Tighten the bolts to 17 N.m (13 lb ft).

  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals