Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - 4L60-E/4L65-E - Introduction & Repair Procedures >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing Center Console Assembly
    GM1234306Courtesy of GENERAL MOTORS CORP.
  1. Remove the front floor console. Refer to Console Replacement in Instrument Panel, Gauges and Console.
    2. Fig 2: View Of shift Control Cable & Shifter
    GM744173Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the shift lock control solenoid wiring harness.
  3. Remove the end of the range selector cable (1) from the transmission control ball stud.
  4. Remove the range selector cable (2) from the floor shift control.
    5. Fig 3: Transmission Control & Bolts
    GM745783Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission control bolts.
  6. Remove the transmission control.
scientia non olet · About Mike's Workshop Manuals