Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 5.3L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Top Of Engine Wiring Harness View
    GM898326Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (3).
    2. Fig 2: Removing/Installing Manifold Absolute Pressure (MAP) Sensor
    GM1509706Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor retaining clip (2) from the intake manifold.
  3. Remove the MAP sensor (1) from the intake manifold.
scientia non olet · About Mike's Workshop Manuals