Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 5.3L - Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Knock Sensor Wiring Harness Assembly
    GM54608Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 5.3L.
  2. Gently pry up the rubber covers.
  3. Disconnect the knock sensor electrical connectors.
    4. Fig 2: View Of Knock Sensors
    GM309864Courtesy of GENERAL MOTORS CORP.
  4. Remove the knock sensors.
scientia non olet · About Mike's Workshop Manuals