Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 5.3L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical - 5.3L.
    2. IMPORTANT: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
  2. Remove the CMP sensor bolt.
  3. Remove the CMP sensor.
scientia non olet · About Mike's Workshop Manuals