Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Linear >> Repair and Diagnosis >> Body & Frame >> Frames, Subframes & Crossmembers >> Frame And Underbody >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Removing/Installing Transfer Case Shield & Mounting Bolts
    GM879617Courtesy of GENERAL MOTORS CORP.
  1. Install the transfer case shield (2) to the transmission support. Ensure that the J-nuts (1) are in place.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transfer case shield mounting bolts (3).

    Tighten:  Tighten the transfer case shield mounting bolts to 16 N.m (12 lb ft).

  3. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About Mike's Workshop Manuals