Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Arc >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 4.2L - Introduction) >> Repair Instructions >> Throttle Body Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Throttle Body Assembly
    GM742490Courtesy of GENERAL MOTORS CORP.
  1. Remove the resonator assembly. Refer to Air Cleaner Outlet Resonator Replacement .
  2. Remove the evaporative emission (EVAP) canister purge line from the throttle body.
  3. Disconnect the throttle body electrical connector.
  4. Remove the throttle body assembly retaining bolts (1).
  5. Remove the throttle body assembly (2) and the gasket from the intake manifold.
  6. Clean the gasket surface.
scientia non olet · About Mike's Workshop Manuals