Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2005 >> 9-7X Arc >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 4.2L - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Camshaft Position Sensor Electrical Connector
    GM487648Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the camshaft position (CMP) sensor.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

  2. Install the CMP sensor electrical connector (1).
scientia non olet · About Mike's Workshop Manuals