Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2004 >> 9-5 Linear, Standard >> Repair and Diagnosis >> Engine Performance >> TRIONIC T7 Fuel Control System >> Technical Description >> Bus messages, Trionic T7 >> Trionic T7 transmits the following information:

Trionic T7 transmits the following information:

TRIONIC T7 INFORMATION SPECIFICATION

Information Unit of measurement User system Description
Engine torque Nm TCM, TC/ABS, ESP The air mass/combustion is converted to torque, unit Nm. This value is used by TCM and TC/ABS/ESP.
Accelerator position % TCM, TC/ABS, ESP The highest requested value of air mass/combustion from the accelerator position or cruise control is selected. This value is converted to a corresponding accelerator position, unit percent. This value is used by TCM and TC/ABS/ESP.
Kickdown ON/OFF TCM, TC/ABS, ESP When voltage from pedal potentiometer 1 corresponds to the kickdown position (under 1.50 V), kickdown ON is sent, unit ON/OFF. This value is used by TCM and TC/ABS/ESP.
Engine RPM RPM MIU, TCM, ACC, TC/ABS, ESP Current engine speed is sent, unit RPM. This value is used by TCM, ACC and MIU.
Coolant temperature (° C) °C MIU, DICE and ACC Current temperature is sent, unit °C. This value is used by ACC, MIU and DICE.
Engine has started ON/OFF ACC, DICE and TC/ABS/ESP When engine speed exceeds 650 RPM, ON is sent, unit ON/OFF. This value is used by ACC, DICE and TC/ABS/ESP.
Turbo measurement values Missing MIU Current air mass/combustion is converted to a value between 0 and 255. This value is used by MIU.
CHECK ENGINE ON/OFF MIU ON, unit ON/OFF, is sent when on-board diagnostics report that the lamp is to be turned on. The value is used by MIU.
SHIFT UP ON/OFF MIU ON, unit ON/OFF, is sent when there is a light load and high engine speed or very high engine speed regardless of lead. This value is used by MIU.
CRUISE lamp ON/OFF MIU ON, unit ON/OFF, is sent when cruise control is activated with the switch. This value is used by MIU.
Consumed fuel volume since start ml MIU The value is 0 ml when the ignition is switched on and accumulates thereafter for each injection, unit mL. This value is used by MIU.
Diagnostics   DICE/diagnostic tool Trionic T7 responds to the diagnostics request from the diagnostic tool via DICE, no unit.