Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2003 >> 9-3 Vector, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (TC/Abs System Version 5.3 - Repair) >> Adjustment - Replacement >> TC/ABS unit with control module >> To fit

To fit

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Illustration For Steps 1-4
G03505513Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Lift the hydraulic unit into position, taking care not to damage the pipes.
  2. Fit the two nuts.

    Tightening torque 20 N.m (14.8 lbf ft) 

  3. Remove the plugs and reconnect the brake pipes. Fit the brake-pipe nipples (rear pipes first) finger tight and then tighten with a spanner.
  4. Plug in the connector.
  5. Fit the main fuse box in place.
    Fig 2: Illustration For Step 5
    G03505514Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Bleed the brake system. See BRAKE SYSTEM .
scientia non olet · About Mike's Workshop Manuals