Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 2000 >> 9-3 Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Bus And Diagnostics Communication) >> Fault diagnosis, general >> Procedure after changing the control module >> Add >> Notes

Procedure after changing the control module: Add: Notes

WARNING: This page is about a different car, the 2003 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.

Once the control module has been fitted and in certain cases SPS programming has been carried out, Tech2 must be used to marry the control unit to the car. Go to the "All" menu and select the control module under "ADD/REMOVE  ". Then select "Add" and follow the instructions. The ignition key must be in ON position. TIS 2000 software may be required.

scientia non olet · About Mike's Workshop Manuals