Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 1995 >> 9000 CS, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Controls - Basic Testing - 3.0L V6) >> Ignition Checks >> Programming ECM

Programming ECM

WARNING: This page is about a different variant/trim than selected.
NOTE: If power supply to Electronic Control Module (ECM) has been interrupted, system must be reprogrammed.

See CAUTION that follows. While driving vehicle on safe terrain, increase engine speed rapidly from 2000 RPM to 4500 RPM.

CAUTION: Because programming occurs at 2750-4500 RPM and requires 3 seconds to complete, perform procedure in a gear that permits operation between these engine speeds.
scientia non olet · About Mike's Workshop Manuals