Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Saab >> 1995 >> 9000 CS, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Air Bag Restraint System >> Diagnosis & Testing >> DTC B1610 - Control Module Programming Error

DTC B1610 - Control Module Programming Error

  1. Turn ignition ON. Clear DTCs and turn ignition OFF. Turn ignition ON and wait 10 seconds, then observe SRS warning light. If DTC B1610 reappears, go to next step. If DTC B1610 does not reappear, no other action is required. Ensure vehicle is in proper working order.
  2. Using ISAT Scan Tool (86 10 834) or equivalent, check if SRS control module is programmed for one or two air bags. If programmed for two, check for other DTCs. If none are present, go to BEFORE REPLACING CONTROL MODULE. If programmed for one, reprogram control module by stepping through command menu until "Programming" is reached. Change air bag configuration to "Driver + Passenger". For further information, consult ISAT manual. Clear DTCs and turn ignition OFF. Turn back ON, wait 10 seconds, and observe SRS warning light. If DTC B1610 does not reappear, fault has been corrected. Ensure vehicle is in proper working order. If DTC B1610 does reappear, replace SRS control module.
scientia non olet · About Mike's Workshop Manuals