Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Porsche >> 2001 >> 911 Turbo, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission, Controls, Case) >> Removing And Installing Selector Lever Cable >> Installation

Removing And Installing Selector Lever Cable: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the selector lever cable (1) through the rear wall to the correct position on the transmission and fasten on the transmission. See Fig 1
    Fig 1: Identifying Selector Lever Cable Routing On Transmission
    G03102722Courtesy of PORSCHE OF NORTH AMERICA, INC.
  2. Insert locking piece in the rear wall and fit rear wall cover.
  3. Fasten cable on support bracket (2). See Fig 2 .
  4. Fit cable holder.
    Fig 2: Fastening Cable On Support Bracket
    G03102723Courtesy of PORSCHE OF NORTH AMERICA, INC.
  5. Move selector lever and transmission to position "P".
  6. Press cable into the open adjuster (1) and close the adjuster (3). The locking sleeve must move to the end position automatically.
  7. Check adjustment of the selector lever cable. See ADJUSTING SELECTOR LEVER CABLE  .
scientia non olet · About Mike's Workshop Manuals