Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Porsche >> 1994 >> 911 Turbo >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System & All-Wheel Drive System >> Trouble Shooting >> Code 23, Right Rear Speed Sensor

Code 23, Right Rear Speed Sensor

  1. Turn ignition off. Unplug ABS/AWD control unit. Using a DVOM, measure speed sensor resistance between pins No. 42 and 43 of ABS/AWD control unit wiring harness. Sensor resistance should be 600-1600 ohms.
  2. If resistance is incorrect, check wiring harness between ABS/AWD control unit and right rear speed sensor (including pins/connectors). If circuit is okay, replace speed sensor.
  3. If resistance is correct, check speed sensor voltage signal at plugs (on right rear trailing arm and at stabilizer bearing). Connect oscilloscope to speed sensor wire.
  4. Depending on oscilloscope, select special input or secondary image display. Turn right rear wheel by hand, at about one revolution per second.
  5. Oscilloscope should display of 2 volts, as measured peak to peak. If voltage signal is incorrect, ensure speed sensor air gap is correct. Ensure wheel bearing or pulse wheel is not damaged or corroded. Repair as necessary.
scientia non olet · About Mike's Workshop Manuals