Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2010 >> Vibe Base, 1.8 8, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Fuel System - 1.8L (Lay) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Exhaust >> Removal Procedure

Removal Procedure

  1. Remove the engine cover. Refer to Engine Cover Replacement .
    2. Fig 1: Identifying Duty Vacuum Switching Valve Connector & Engine Wire Harness Clamps
    GM2016625Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the duty vacuum switching valve connector (3) and the 3 engine wire harness clamps.
    3. Fig 2: Locating Camshaft Position Sensor
    GM2016626Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position sensor connector (1).
    4. Fig 3: View Of Camshaft Position Sensor Bolt
    GM2016628Courtesy of GENERAL MOTORS CORP.
  4. Remove the bolt and the camshaft position sensor (1).
scientia non olet · About Mike's Workshop Manuals