Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2010 >> Vibe Base, 1.8 8, Standard >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Rear Wheel Speed Sensor Replacement (AWD) >> Installation Procedure

Installation Procedure

    Fig 1: Speed Sensor & Retaining Bolt
    GM839787Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the wheel speed sensor (2) to the steering knuckle.

    Tighten:  Tighten the rear wheel speed sensor bolt (1) to 8 N.m (71 lb in).

    2. Fig 2: Speed Sensor Bolt & Nut
    GM839777Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt (1) and nut (2) which retains the wheel speed sensor harness to the upper arm and suspension member.

    Tighten:  Tighten the bolt and nut bolt to 5 N.m (44 lb in).

    3. Fig 3: Speed Sensor Harness & Bolt
    GM839772Courtesy of GENERAL MOTORS CORP.
  3. Install the bolt (2) which retains the wheel speed sensor harness (1) to the vehicle.

    Tighten:  Tighten the bolt and nut bolt to 5 N.m (44 lb in).

    4. Fig 4: Identifying Wheel Speed Sensor Electrical Connector
    GM2022985Courtesy of GENERAL MOTORS CORP.
  4. Reposition the wheel speed pigtail harness through the body. Install the grommet.
  5. Connect the wheel speed sensor electrical connector (1).
  6. Lower the vehicle.
  7. Install the rear seat bottom and seat back. Refer to Rear Split Folding Seat Back Replacement .
    8. Fig 5: Fuel Tank Filler Pipe Protector & Protector Bolts
    GM839756Courtesy of GENERAL MOTORS CORP.
  8. Install the fuel tank filler pipe protector (1). Secure with 3 bolts (2).
  9. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About Mike's Workshop Manuals