Procedure A - Registration of Additional Keys

This procedure will register an additional vehicle key to the vehicle using the scan tool. Up to 5 vehicle keys may be programmed to a single vehicle. The registration procedure will exit if the steps are not completed in the specified time.

If the ignition cylinder is replaced, remove the transmitter from the original master key and install onto a new key. Use this as the master key.

1. Turn the ignition ON with an already learned master key.
2. Within 120 seconds of turning the ignition ON, select Programming Additional Keys on the scan tool. The security indicator will be illuminated.
3. Within 20 seconds of selecting Programming Additional Keys, remove the master key from the ignition. The security indicator will remain illuminated.
4. Within 10 seconds of removing the master key, insert the key to be registered. The security indicator will blink. After 60 seconds, the key will be registered and the security indicator will not be illuminated.
5. If additional keys are required to be registered, begin at step 1.