Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2010 >> Vibe Base, 1.8 8, Standard >> Repair and Diagnosis >> Body & Frame >> Fixed And MOVEABLE Windows System >> Repair Instructions >> Liftgate Window Replacement >> Removal Procedure

Removal Procedure

    WARNING: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
    NOTE: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim.
  1. Open the liftgate.
  2. Remove the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
  3. Remove the rear wiper motor. Refer to Liftgate Wiper Motor Replacement .
  4. Remove the rear spoiler. Refer to Rear Spoiler Replacement .
  5. Fig 1: Identifying Rear Window Defogger Electrical Connector
    GM2015360Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the rear window defogger electrical connector (1).
  7. WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  8. Cover the following parts to protect from broken glass:
    1. The rear stowage compartment
    2. The defroster outlets and A/C outlets
    3. The seats and carpeting
  9. Fig 2: Separating Urethane Adhesive From Window
    GM71179Courtesy of GENERAL MOTORS CORP.
    NOTE: Keep the cutting edge of the tool against the window.
  10. Separate the urethane adhesive from the window.
    • Leave a base of urethane on the pinchweld flange.
    • The only suitable lubrication is clear water.
    • Use J 24402-A  , J 39032  or equivalent in order to remove the window. See Special Tools .
  11. Fig 3: Identifying Adhesive Dam & Liftgate Window
    GM2015376Courtesy of GENERAL MOTORS CORP.
  12. With the aid of an assistant, use the suction cups in order to lift the liftgate window (1) from the opening.
  13. Remove the adhesive dam (2) from the liftgate window (1).