Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2010 >> Vibe Base, 1.8 8, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Fuel System - 1.8L (Lay) - Repair Instructions >> Repair Instructions >> Heated Oxygen Sensor Replacement - Sensor 2 >> Removal Procedure

Removal Procedure

  1. Disconnect the heated oxygen sensor connector.
    2. Fig 1: View Of Wire Harness Clamp Bracket & Wire Harness Clamp
    GM2016682Courtesy of GENERAL MOTORS CORP.
  2. Remove the grommet (1) and pull the sensor connector out of the cabin through the floor panel.
  3. Remove the wire harness clamp bracket and disconnect the wire harness clamp.
    4. Fig 2: Identifying Heated Oxygen Sensor
    GM2016684Courtesy of GENERAL MOTORS CORP.
  4. Using the J-39194-C:  wrench (1), remove the heated oxygen sensor.
scientia non olet · About Mike's Workshop Manuals