Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2010 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System & Fuel System - 3.5L - Repair Instructions) >> Repair Instructions >> Fuel Line Replacement - Engine >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Feed Pipe
    GM1239037Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel feed pipe to the fuel rail Refer to Metal Collar Quick Connect Fitting Service .
    2. CAUTION: Refer to Fastener Caution .
  2. Install the engine fuel feed pipe fasteners located on the engine.

    Tighten:  Tighten the fuel feed pipe fasteners to 10 N.m (89 lb in).

  3. Connect the engine fuel feed pipe to the chassis fuel flex hose. Refer to Metal Collar Quick Connect Fitting Service .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Inspect for leaks using the following procedure:
    1. Turn ON the ignition, with the engine OFF for 2 seconds.
    2. Inspect for fuel leaks.
    3. Turn OFF the ignition for 10 seconds.
    4. Turn ON the ignition.
  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About Mike's Workshop Manuals