Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2010 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System & Fuel System - 3.5L - Repair Instructions) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: ECT Sensor
    GM1275978Courtesy of GENERAL MOTORS CORP.
    CAUTION: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
  1. Coat the threads with sealer GM P/N 13246004 (Canadian P/N 10953480) or equivalent.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ECT sensor.

    Tighten:  Tighten the ECT sensor to 20 N.m (15 lb ft).

  3. Connect the ECT electrical connector.
  4. Fill the cooling system. Refer to Cooling System Draining and Filling (LY7, LZE, LZ4, LZ9) .
scientia non olet · About Mike's Workshop Manuals