Visual/Physical Check
- Ensure that the control module grounds are clean, tight, and correctly located.
- Ensure that the vacuum hoses are not split, kinked, and properly connected, as shown on the Vehicle Emission Control Information label.
- Ensure that the air filter is clean and free from restrictions.
- Ensure that there is no water intrusion in connectors terminals and components.
- Inspect the air intake ducts for the following conditions:
- Collapsed
- Damaged areas
- Looseness
- Incorrect installation
- Leaking
- Inspect for air leaks at the throttle body mounting area, the mass air flow (MAF) sensor and intake manifold sealing surfaces.
- Inspect the wiring harness for the following conditions:
- Poor connections
- Pinches
- Cuts
- Inspect for loose, damaged, unseated, or missing sensors/components.
- Inspect the terminals for corrosion and correct contact.