Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Vibe GT, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.4L (Lax) - Introduction >> Repair Instructions >> Fuel Pressure Regulator Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Pressure Regulator Assembly O-Rings
    GM2016690Courtesy of GENERAL MOTORS CORP.
  1. Apply oil to 2 new O-rings and then install them to the fuel pressure regulator assembly.
    2. Fig 2: View Of Fuel Pressure Regulator Assembly
    GM2016693Courtesy of GENERAL MOTORS CORP.
  2. Install the fuel pressure regulator assembly.
  3. Install the fuel pump for AWD.
  4. Install the fuel pump for FWD.
  5. Install the fuel sender gage assembly for AWD.
  6. Install the fuel sender gage assembly for FWD.
  7. Install the fuel suction tube assembly for AWD.
  8. Install the fuel suction tube assembly for FWD.
  9. Install the fuel pump gage retainer for AWD.
  10. Install the fuel pump gage retainer for FWD.
  11. Connect the fuel tank vent hose sub-assembly for FWD.
  12. Connect the fuel tank main tube sub-assembly.
    13. CAUTION: Refer to Battery Disconnect Warning .
  13. Connect the cable to the negative battery terminal.
  14. Inspect for a fuel leak.
  15. Install rear floor service hole cover for AWD.
  16. Install the rear seat cushion assembly. Refer to Rear Seat Cushion Replacement .
scientia non olet · About Mike's Workshop Manuals