Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Vibe Base, 1.8 8, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 1.8L (Lay) - DTC P0010 To DTC P0420 >> DTC P0010 or P0013 >> Circuit/System Verification

Circuit/System Verification

    IMPORTANT: All CMP actuator system DTCs must be cleared before the CMP actuator solenoid scan tool output control is enabled.
  1. Engine running at normal operating temperature, command the CMP actuator solenoid ON with the scan tool. The engine should run rough or stall.
  2. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About Mike's Workshop Manuals