Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Vibe Base, 1.8 8, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 1.8L (Lay) - Introduction >> Repair Instructions >> Heated Oxygen Sensor 2 Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the heated oxygen sensor connector.
  2. Remove the grommet and pull the sensor connector out of the cabin through the floor panel.
    3. Fig 1: View Of Wire Harness Clamp Bracket & Wire Harness Clamp
    GM2016682Courtesy of GENERAL MOTORS CORP.
  3. Remove the wire harness clamp bracket and disconnect the wire harness clamp.
    4. Fig 2: Identifying Heated Oxygen Sensor
    GM2016684Courtesy of GENERAL MOTORS CORP.
  4. Using SST  , remove the heated oxygen sensor.
scientia non olet · About Mike's Workshop Manuals