Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent GXP, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.4L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAP Sensor, Bracket & Retaining Bolt
    GM1087786Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1) to the intake manifold.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the MAP sensor retaining bracket (2) and bolt (3).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the MAP sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals