Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Engine Control Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a scan tool, capture the ECM data.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the ECM water deflector.
  4. Fig 1: Identifying ECM Upper Retaining Tabs
    GM1655954Courtesy of GENERAL MOTORS CORP.

    Release the ECM upper retaining tabs.
  5. Fig 2: Identifying ECM Electrical Connector
    GM1655955Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the ECM electrical connectors.
  7. Remove the ECM from the bracket.