Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
    Fig 1: View Of Accelerator Pedal Position Sensor Electrical Connector
    GM858238Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) retainer.
  2. Disconnect the accelerator pedal position (APP) sensor electrical connector.
  3. Reposition the carpet to access the lower nut.
  4. Fig 2: Identifying Accelerator Pedal Assembly
    GM1848812Courtesy of GENERAL MOTORS CORP.

    Remove the accelerator pedal nuts.
  5. Remove the accelerator pedal assembly.
scientia non olet · About Mike's Workshop Manuals