Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1834957Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
    3. Fig 2: Identifying MAF/IAT Sensor
    GM1834958Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAF/IAT sensor screws.
  4. Remove the MAF/IAT sensor from the air cleaner assembly.
  5. Remove the MAF/IAT sensor seal.
scientia non olet · About Mike's Workshop Manuals