Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the knock sensor and tighten the knock sensor bolt.

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1836687Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (2) to the bank 2 knock sensor.
  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals