Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1836545Courtesy of GENERAL MOTORS CORP.
  1. Remove the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (LY7) .
  2. Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat Shield Replacement (LY7) .
  3. Disconnect the engine wiring harness electrical connector (1) from the bank 1 knock sensor.
    4. Fig 2: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  4. Loosen the knock sensor bolt and remove the knock sensor.
scientia non olet · About Mike's Workshop Manuals