Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls And Fuel - 3.6L - Introduction) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Crankshaft Position (CKP) Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft position sensor.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the crankshaft position sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1836545Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector to the CKP sensor.
  4. If equipped with all AWD, install the transfer case. Refer to Transfer Case Assembly Replacement .
  5. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals