Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Intake Air Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Intake Air Valve Bolts
    GM1862033Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Position the intake air valve to the IAH and install the intake air valve bolts and tighten to 20 N.m (15 lb ft).
    2. Fig 2: View Of Engine Wiring Harness Electrical Connector
    GM1862030Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (2) to the intake air valve.
  3. Install the charge air cooler outlet pipe. Refer to Charged Air Cooler Hoses/Pipes Replacement (Inlet) or Charged Air Cooler Hoses/Pipes Replacement (Outlet) .
scientia non olet · About Mike's Workshop Manuals