Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor 2 Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of IAT Sensor
    GM1733089Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the IAT sensor to the center intake manifold and tighten to 25 N.m (18 lb ft).
  2. Connect the IAT sensor (2) electrical connector.
  3. Install the air intake pipe. Refer to Air Intake Pipe Replacement .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals