Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Fuel Injection Pump Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Injection Pump
    GM1336114Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel injection pump to the block.
  2. Install the fuel injection pump bolts and tighten to 21 N.m (15 lb ft).
  3. Install the hoses to fuel lines.
  4. Position the injection pump hose clamps at the fuel line.
  5. Connect the injection pump electrical connector.
  6. Install the center intake manifold. Refer to Center Intake Manifold Replacement (LMM) .
  7. Install the left fuel rail fuel feed pipe. Refer to Fuel Injection Fuel Feed Front Pipe Replacement - Right Side .
  8. Install the left fuel rail fuel feed pipe. Refer to Fuel Injection Fuel Feed Front Pipe Replacement - Left Side .
  9. Install the thermostat housing crossover.
    10. Fig 2: Identifying Wiring Harness Retainer
    GM1601448Courtesy of GENERAL MOTORS CORP.
  10. Prime the fuel system. Refer to Fuel System Priming .
  11. Start the engine.

    If the engine stalls, repeat the above step.

  12. Once the engine starts, inspect for fuel leaks.
scientia non olet · About Mike's Workshop Manuals