Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Control System & Fuel System - 6.6L LMM - Introduction) >> Repair Instructions >> Exhaust Pressure Differential Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Exhaust Differential Pressure Sensor
    GM1862637Courtesy of GENERAL MOTORS CORP.
  1. Position the exhaust differential pressure sensor to the frame.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the exhaust differential pressure sensor bracket bolt (2) and tighten to 9 N.m (80 lb in).
  3. Install the exhaust differential pressure sensor pipe assembly hoses to the sensor.
  4. Position the exhaust differential pressure sensor pipe assembly hose clamps (1).
    5. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1862627Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (1) to the exhaust differential pressure sensor.
  6. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals