Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> Torrent Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Engine Control System & Fuel System - 4.3L - Introduction) >> Repair Instructions >> Knock Sensor 2 Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Savana and 2009 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Wiring Harness & Components
    GM1877018Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Reposition the knock sensor sleeve (2) down, away from the knock sensor.
  3. Disconnect the engine wiring harness electrical connector from the knock sensor (1).
    4. Fig 2: View Of Knock Sensor & Bolt
    GM1877020Courtesy of GENERAL MOTORS CORP.
  4. Remove the knock sensor bolt and sensor.
scientia non olet · About Mike's Workshop Manuals