Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake caliper bracket (1).
- Perform the following procedure before installing the brake caliper bracket mounting bolts.
- Remove all traces of the original adhesive patch.
- Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
- Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488).
- Install the caliper bracket mounting bolts (2).
- JH5: Tighten the bolts to 175 N.m (129 lb ft).
- JH6, JH7: Tighten the bolts to 300 N.m (221 lb ft).
- Install the anti-rattle clips to the brake caliper bracket.
- Install the brake pads to the brake caliper bracket.
- Slide the brake pads in until they contact the rotor.
- Install the brake caliper. Refer to Front Brake Caliper Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Lower the vehicle.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
CAUTION:
Refer to Fastener Caution
.