Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2009 GMC Savana Special, 2009 GMC Savana Camper Special, 2009 GMC Savana, 2009 Chevrolet RV Cutaway, and 2009 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear header speaker to the rear header speaker housing.
- Install the screws in order to retain the rear header speaker to the rear header speaker housing and tighten to 2 N.m (18 lb in).
- Connect the electrical connector to the speaker.
- Install the rear header speaker housing to the vehicle.
- Install the nuts in order to retain the rear header speaker housing to the vehicle and tighten to 6 N.m (53 lb in).
- Install the rear header trim panel, if equipped.
CAUTION:
Refer to Fastener Caution
.