Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAF Harness Connector
    GM1949902Courtesy of GENERAL MOTORS CORP.
  1. Ignition OFF.
  2. Remove the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
  3. Remove the mass air flow (MAF) harness connector (2) from the MAF sensor.
  4. Remove the MAF sensor air box retaining clamps (1).
    5. Fig 2: Identifying MAF Sensor To Air Box Retaining Screws
    GM1949904Courtesy of GENERAL MOTORS CORP.
  5. Remove the MAF sensor to air box retaining screws (1).
    6. Fig 3: Identifying MAF Sensor Seal
    GM1949903Courtesy of GENERAL MOTORS CORP.
  6. Remove the MAF sensor seal and discard the seal.
scientia non olet · About Mike's Workshop Manuals