Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Knock Sensor (KS) Electrical Connector & Retaining Bolt
    GM1949898Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the KS (3) to engine block retaining bolt (2) and tighten to 23 N.m (17 lb ft).
    2. Fig 2: Identifying Knock Sensor (KS) Electrical Connector & Retaining Bolt
    GM1949898Courtesy of GENERAL MOTORS CORP.
  2. Install the knock sensor (KS) electrical (1) connector to the KS (2).
  3. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals